NitroMors All Purpose Paint and Varnish Remover Spray Usage Instructions

Preparation: 

+ Extinguish all ignition sources (fires, boilers, cooker, pilot lights etc.) DO NOT SMOKE
+ Wear suitable protective gloves and safety goggles. 
+ Work outside if possible.
+ Ensure good ventilation when working indoors.
+ Protect surrounding area with polythene sheeting.
+ Do not use in direct sunlight.
+ Do not use in enclosed spaces, eg. cellars, floor wells etc.

Usage Instructions:
1. Shake thoroughly before use
2. Spray liberallyonto the surface or component from a distance of 15 to 20cm, ensuring a good coating.
3. Leave for up to 15 minutes to soften or dissolve the paint
4. Once the paint has blistered, apply a second coat. Agitate with a wire or nylon brush as appropriate, leave up to 40 minutes, if dried out re-apply.
5. Remove blistered and softened paint with a scraper or shavehook . In difficult areas use an old nylon toothbrush. Repeat as necessary. Wash off with detergent in cold water and a nylon scourer or use white spirit and wire wool to avoid raising the grain on fine or laminated woods. Allow to dry thoroughly and rub down with fine sandpaper or wire wool prior to refinishing.

NitroMors All Purpose Paint and Varnish Remover Spray Technical Information

Barcode: 5010373142752
Weight: 0.81kg