Pure Spa Whirlpool Bath Pipe Cleaner and Degreaser Usage Instructions

 Recommended Dilution:  (Average size bath)

Dilute Pure Spa Whirlpool Cleaner and Degreaser with water up to 600:1 – as a guide this is approx 250mls of cleaner per average bath of 150 Litres of water (this is based on the average volume of a 1700mm x 750mm bath). Increase for larger baths.

For an Intensive/purge clean eg. if your bath has not been cleaned in some time, Pure Spa Whirlpool Cleaner and Degreaser can be used up to max dilution of 80:1. This could mean using half – one full bottle of cleaner per application, the solution may then be left in overnight. (see user instructions on bottle).

1. Fill the bath with warm water (approx. 35ºC) to cover the jets by approx. 1-2 inches.
2. Add the correct amount of Pure Spa Whirlpool Cleaner and Degreaser to the water.
3. Close the air control (set to minimum) and run whirlpool system for 2-5 minutes. Do Not leave unattended as the product may foam.
4. Turn off and let stand for approx. 2-3 hours or overnight if necessary, activate whirlpool system intermittently to agitate the cleaning solution through the pipework.
5. Drain the bath, refill with cold water, run whirlpool system for 2 minutes, drain the bath and wipe interior surface.

Pure Spa Whirlpool Bath Pipe Cleaner and Degreaser Technical Information

Barcode: 5060217150016
Weight: 3.12kg

Health and Safety: Non-hazardous. In the event of eye contact, rinse with plenty of clean water, if irritation persists immediate medical attention should be sought. DO NOT INGEST DO NOT MIX WITH OTHER CHEMICALS KEEP OUT OF REACH OF CHILDREN

Contains: Silicates < 2% Cationic suractants < 2% Non Ionic Surfactants < 10% Nitrilotriacetate < 5%