Rustins Quick Dry All Surface All Purpose Paint (ASAP) Cream Usage Instructions

Preparation: The surface must be clean and free from dust and any loose paint, wax, grease, dirt, fungal growth or solid matter likely to interfere with the adhesion of the paint. Do not apply to damp areas. Sources of damp should be eliminated before applying the paint. The product can be applied to surfaces without the need of a primer. However on metal improved protection will be achieved if an anti-corrosive metal primer such as Rustins Red Oxide Primer or Rustins Galvanised Metal Primer is first applied. The product can also be applied directly to timber but a suitable primer such as Rustins Quick Drying Primer and Undercoat will help to reduce the appearance of the grain of the timber if this is important.
Application: STIR WELL BEFORE USE. Do not thin the product. Apply evenly by brush. One or two coats should be applied allowing 3-4 hours between coats in warm dry conditions. Cold damp conditions will significantly extend the drying times. Do not apply outdoors when foggy or likely to rain before the paint has dried.
Coats: 1 coat is usually sufficient. A second coat may be applied for improved durability.
Drying Time: Approximately 30 minutes, depending on temperature and humidity.
Re-coating Time: Approximately 3-4 hours
Application Temp. Ideally 15-25°C. Do not apply if rain imminent.
Maintenance: The surface may be washed with a mild detergent solution and a scrubbing brush and re-coated if necessary.
Compatibility: May be applied to a wide range of surfaces and paints but test for compatibility and adhesion if in doubt.
Settlement: STIR WELL BEFORE AND DURING USE.
Clean-Up: Remove excess product from brushes before cleaning. Clean brushes whilst wet with water. Hard brushes can be cleaned with Rustins Brush Restorer.

Rustins Quick Dry All Surface All Purpose Paint (ASAP) Cream Technical Information

Barcode: 5015332001668
Weight: 0.5kg